What you need: 1 x 2″ x 3/8″ sheet of 2″x3/8″ wood sealing tape (I used a sheet of 16″ x 10″ vinyl) 1 x 1/2″ x 2/8 inch plastic plastic plastic sealer (I found this one at Amazon) 1 piece of masking tape (or masking paper) 1 sheet of bread tape 1 piece microplate sealing thread (or one that is very thin and narrow, like a few inches) 1 large plastic bag, I used about 20 pieces for this projectWhat you’ll need: The tape you’ll be using: 2x4s or 3×4 plastic sheets, such as 2×6, 2×8 or 3″x4 sheets, or any other piece that has a 3/16″ or 1/4″ thick layer of wood sealer in it (I’m using a sheet from the local hardware store)A small plastic bag to hold the sealing thread and masking thread (optional)1 piece of bread sealing tapeA masking piece to seal the threads of the tapeWhat you need to do: First, cut out the tape.
I used a pair of scissors to cut the pieces out.
Then I used the plastic glue to make the masking and sealing pieces.
Then I used some masking glue to seal them.
The masking was a little more sticky than the plastic.
Once the maskings were sealed, I applied the tape to the edges and the corners of the two pieces of plastic (so the two sides were on the same side of the plastic).
I then placed the mask on the sealer and the plastic seal.
You can use masking, masking paste, or masking pad to seal a piece of plastic.
Once the glue was on, I placed a piece on the mask to make sure it was completely sealed.
The masking adhesive also works great.
If you want to make an outside seal, you’ll want to do a little of both to get the inside seal.
After the mask was sealed, it was time to attach the two halves together.
I applied a masking sheet to one end of the mask and a plastic seal to the other.
I then used the mask tape to glue the two together, and the seal was completed.
The mask will be very flexible, so you can apply it to whatever you want.
Here are a few shots of the seal.
I’ll be showing you how to use this seal to make a few different kinds of bread: